GODIAG GT100 ECU Connector

As we all know, a fuel injector test may require longer wires to assist with the testing. This article will show you how to make an extension cable for the Godiag GT106 Plus power cord. Tools Required: 1pc x GT106 Plus Power Cord with Fuse 2pcs x Clamps 2pcs x Rubber Protective Cover 1pc x Extension Cable 1pc x Automatische Abisolierzange 1pc x Isolierband Steps: 1. Use the automatische abisolierzange to peel off one end of the GT106 Plus power cord and the extension cable. 2. Connect the GT106 Plus power cord's red wire and the extension cable's red wire, and then fix them with an isolator band. Both black wires are connected in the same way. 3. Connect the other end of the extension cable to the clip. First, put on the rubber protective cover, then connect the wire to the clip like this, clamp it, and finally put the rubber protective cover on the clip. Click on the video below to view the full tutorial: www.obd2shop.co.uk

GODIAG GT106 PLUS is an adapter that can convert heavy truck diagnostic interface from 24V to 12V. With it, we can use the LAUNCH vehicle equipment for truck diagnosis. Converting the truck's 24V K-Line communication protocol to 12V K-Line can prevent the LAUNCH diagnostic head from burning. Following is the tutorial on how to convert truck K-line from 24v to 12v. As we can see, the Launch- x431 diagnostic tool requires 9-18 voltage. Connect ECU & GODIAG GT100 to test the voltage. The voltage from GT100 is 30V; The voltage from the ECU is 30V. The K-Line voltage is 29V. Connect GT106 PLUS to GT100 for a test. Its output voltage is 12.7V and its input voltage is 30.7V. So that we can plug the Launch-x431 tool safely. Now we can diagnose the truck ECU. Exactly a useful and easy tool. www.obd2shop.co.uk